Howto:LLDP on Juniper EX Switches for innovaphone devices
Applies To
This information applies to
- IP 3000, V10
Build 01-4001 and later.
More Information
Problem Details
System Requirements
Installation
You have two sperate VLANs: - Clients (VLAN-ID 2) - VoIP (VLAN-ID 4) The goal is that the VoIP Devices are using vlan VoIP (ID 4) and normal clients are using vlan VoIP (ID 2) on the same switch port. With Juniper switches you can do this with an interface range including the ports which are used for the clients and VoIP phones. interface-range LLDPorts {
member-range ge-0/0/0 to ge-0/0/23; unit 0 { family ethernet-switching { port-mode access; vlan { members Clients; } } } }
Make sure, that you define an acces port only with the Client VLAN untagged. Now you have to configure the two vlans used for the phones and clients: vlans {
Clients { vlan-id 2; } VoIP { vlan-id 4; }
}
Then you have to define the lldp-med protocol on the ports which you would liket to use with your phones and clients (in that case is is the above defines interface-range LLDPPorts, but you can also specify any other port)
protocols {
lldp-med {
interface LLDPorts;
}
}
At last you have to define which voip Vlan you would like to use on these ports: ethernet-switching-options {
voip { interface LLDPorts { vlan VoIP; forwarding-class assured-forwarding; }
}
After an reboot you should check the chosen VLAN on your phone: